SolarEdge SEHAZB-SWITCH-MTR, Quick Installation Manual, Page: 2 / 2

3. Drill the holes and mount the device using screws and nuts. Fasten the unit to the wall.
4. Release the three internal screws at the bottom of the device, and remove the cable bracket.
5. Connect
the load wires to the terminal blocks (see
Figure
2 ). w
Figure 2: AC Switch connections
6. Place the cable bracket over the cables and fasten using the screws.
7. Attach the cover to the device and fasten the screws.
8. For configuration and troubleshooting, refer to
http://www.solaredge.com/sites/default/files/se-device-control-switch-installation-guide.pdf .
Specifications
ELECTRICAL SERVICE SEHAZB-SWITCH-MTR
Units
Operating Voltage Range - Line to Neutral 90 - 250 Vac
AC Frequency 50/60 Hz
Maximum Active Power Measurement
3
kW
Maximum Load Current 13 A
COMMUNICATION
Supported Communication Protocol ZigBee Home Automation
Nominal Transmit Power 3 dBm
Operating Frequency Range 2.4 - 2.5 GHz
Outdoor (LOS) Range 100 m
50 m
Indoor Range
1
STANDARD COMPLIANCE
Radio ETSI EN 300 328 V 1.8.1, ETSI EN 301 489-1, ETSI EN 301 489-17
Safety EN 60335-1, EN 60335-2-30, EN 50371
Immunity EN 55014-2
Emissions EN 55014-1, EN 61000-3-2, EN 61000-3-3
INSTALLATION SPECIFICATIONS
Operating Temperature Range 0 to +50 °C
Protection Rating IP30
Dimensions (H x W x D) 110 x 70 x 25 mm
Mounting Type Wall mount
1
Approximate values. May differ depending on specific installation conditions.
AC Switch
Quick
Installation Guide MAN-01-00288-1.
1
2
AC Switch with Meter Quick Installation Guide