If applicable, turn on all devices (battery, Energy Meter) connected to the inverter,
so that the devices may be auto-detected.
To activate the inverter:
1. Turn ON the AC circuit breaker on the main distribution panel.
2. Open SetApp and follow the on-screen instructions (scan the inverter barcode;
move the ON/OFF/P switch to P position for 2 seconds and release).
SetApp creates a Wi-Fi connection, upgrades the inverter firmware and activates the
inverter.
3. When the activation is complete, do one of the following:
Select
Connect to Another Device
to continue activating additional inverters.
Select
Start Commissioning
for pairing and other system configuration.
Step 2: Commissioning and Configuring the
Installation
This section describes how to use the SetApp menus for commissioning and
configuring the inverter settings.
Menus may vary in your application depending on your system type.
To access the Commissioning screen:
Do one of the following:
During first time installation: Upon activation completion, in the SetApp, tap
Start
Commissioning
.
If the inverter has already been activated and commissioned:
If not already ON - turn ON AC to the inverter by turning ON the circuit breaker
on the main distribution panel.
If not already ON - move the Connection Unit switch to the ON position.
If the Backup Interface is installed - turn on the inverter circuit breaker in the
Backup Interface and make sure the Backup Interface's ON/OFF switch is in the
ON position.
Open SetApp and follow the on-screen instructions (scan the inverter QR code,
move the ON/OFF/P switch to P position for 2 seconds and release).
The mobile device creates a Wi-Fi connection with the inverter and displays the
main Commissioning screen.
Chapter 6: Activating, Commissioning and Configuring the System
41
Single Phase Energy Hub Inverter MAN-01-00812-1.1
Summary of Contents for Energy Bank
Page 68: ......
