For more information please visit www.solargreentech.co.uk
©copyright 2022
Continue to next page.
Solar GreenTech 1200 User Guide
switch is in the up position the switch is on, you can test this switch with the
test button which will trip will the switch down disconnecting the 240v supply to
the sockets. Simply reset by pressing the switch back to the top position.
should a fault occur the switch trip out. If the switch does trip out due to a
faulty appliance its very important that you disconnect the faulty appliance
before reinstating the switch to the up/on position. for further information on
the regulations around earthing for mobile generators please see the extract
Earthing conforms to the IET on-Site Guide BS 7671 :2018 Extract 2.4.1
Portable generator isolated from earth printed at the back of this booklet.
Fig 9: The LCD power consumption meter when illuminated will give
information such as the 240v being supplied to the 3 pin outlet sockets, the
amount of current and wattage your appliance is using. This will help ensure
you do not overload the units capabilities.
Fig 10: The folding solar panel. Ensure that you only handle the DC output
lead while the solar panel is folded, as soon as the panel is exposed to any
form of light the panel begins to generate power, the lead becomes live and
can generate 22v offload, we recommend that you plug the panel lead into the
unit first and then open the panel before placing the panel facing towards the
sun. See soler panel user manual.
Fig 11: The cable gates. It's extremely important that when the lid is closed
before use in a wet environment that the cables sit directly in the centre of the
cable gate foam. Please take extreme care to ensure this is done correctly as
this can ensure the IP65 rating for weatherproof use, failure to do so may allow
water to access the unit therefore not provide an IP65 weatherproof rating.
Fig 12 Fig 13: and Fig 14: These illustrate the positions in which the unit
should be operated in. Fig 12 demonstrates the unit lid must be closed when
operating in this position. Fig 13 illustrates the position the unit can be
operated on dry conditions only. Fig 14 illustrates the position the unit must be
operated in under wet conditions. It is extremely important that you follow
these instructions to ensure the unit remains IP65 water resistant.
