Professional, Vision
7
1408TU0710
J
Mounting of grounding terminal
on frame
The grounding terminal must be placed on the
frame in such a way that the screw touches the
grounding hole. Using a screwdriver, install the
screw into the grounding hole until its head is
flush with the base and the base is flush with the
frame.
Then, turn the screw another quarter or half turn.
The thread-cutting screw should be torqued by
20.4 lb in and 24,8 lb in (2.3 and 2.8 Nm).
J
Wire placement
Insert the cable into the wire slot. Then push in
the wire on both ends into the slot. (The wire slot
will cause the wire to be slightly curved as shown.)
J
Termination
The slider must be engaged (slider covers the
base). Using cable clamps, move the slider over
the base until it covers the base. This terminates
the wire. To open the slider a slotted screwdriver
can be used.
