8
Useful Information
Radiator not getting warm
POWER SUPPLY:
Make sure the power supply to the Radiator and Pr
-
4 reviver unit is good.
If there is no power to the radiator, manually override the receiver unit. (See page 11
-
12)
THERMOSTAT WHEEL:
Make sure the thermostat wheel is set to position
“5”
WARNING LAMPS:
Check that the Failure Warning Laps are not illuminated.
If they are please contact your supplier.
SAFETY THERMOSTATS:
There are two over heat limiters inside the radiator. To ensure the internal fluid does not exceed 100
0
C . If the over
heat limit is exceeded the radiator will switch off and these warning lamps will illuminate.
Over heating can occur if the air flow through the radiator is obstructed.
Before contacting your supplier, isolate the heater from the power supply and allow 60 minutes for the radiator to
cool down. Remove any obstruction clothing etc and start the radiator again .
