SS7 Quick Start Guide
19
MoveChannelToTrunkGroup
MoveRangeOfChannelsToTrunkGroup
RemoveChannelFromTrunkGroup
EnableChannel
DisableChannel
EnableRangeOfChannels
DisableRangeOfChannels
The following example shows 2 trunk groups (500 and 600). Each trunk group has
12 channels.
Trunk group 500 has channels 1,3,5,7,9,11,13,15,17,19,21,23
Trunk group 600 has channels 0,2,4,6,8,10,12,14,16,18,20,22
To create the 2 trunk groups perform the following:
1.
Select EdgeIQ from the IQadmin application.
2.
Ensure the Shelf, Card, Span, Channel parameters are set to -1, to create an
empty trunk group.
3.
CreateSS7TrunkGroup
500, SS7_MINI_CTL_1 , 15728412 ,-1,-1,-1,-
1,MOST_IDLE,0,0,61,62,0
4.
CreateSS7TrunkGroup
600, SS7_RD_1 , 460809 ,-1,-1,-1,-
1,MOST_IDLE,0,0,61,62,0
5.
Use
MoveChannelToTrunkGroup
to move each one of the 12 channels into the
trunkgroup. Notice the InterfaceID which is the last parameter is the SS7 CIC to
assign to the channel. Therefore starting channel 0 gets CIC 5, channel 2 gets
CIC 6 and so on until channel 22 gets CIC 16. The trunkgroup 600 is configured
the same but the channels in use will be 1, 3, 5 etc.
movechanneltotrunkgroup 30,3,0,0,500,5
movechanneltotrunkgroup 30,3,0,2,500,6
movechanneltotrunkgroup 30,3,0,4,500,7
movechanneltotrunkgroup 30,3,0,6,500,8
movechanneltotrunkgroup 30,3,0,8,500,9
movechanneltotrunkgroup 30,3,0,10,500,10
Summary of Contents for SS7
