SOLAC Elogio, Instructions For Use Manual, Page: 6 / 40

ENGLISH EN
DESCRIPTION
A Function and heat intensity knob
B Thermostat control knob
C Pilot light
D Carry handle
USE AND CARE:
-Fully extend the appliance’s power cable
before each use.
- Do not use the appliance if the on/off switch
does not work.
-Do not move the appliance while in use.
-Use the appliance handle, to carry it or move
it.
-Do not use the appliance if it is tipped up and
do not turn it over.
-Do not turn the appliance over while it is in
use or connected to the mains.
-If you use the appliance in a bathroom or
similar place, unplug the appliance from
the mains when it is not in use, even if it is
only for a short while, as proximity to water
involves a risk, even if the appliance is
disconnected.
-Disconnect the appliance from the mains
when not in use and before undertaking any
cleaning task.
-Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
-Do not store the appliance if it is still hot.
-Do not store the appliance on areas where
the temperature could be lower than 2ºC.
-Make sure that dust, dirt or other foreign
objects do not block the fan grill on the
appliance.
-Never leave the appliance unattended while
in use.
-Never leave the appliance connected and
unattended if is not in use. This saves energy
and prolongs the life of the appliance.
-Do not use the appliance to dry pets or
animals.
-Do not use the appliance to dry textiles of any
kind.
-CAUTION: User can’t sleep when appliance
is under use; there is a risk of injuries.
-Turn the thermostat control to the minimum
setting. This does not mean that the iron is
switched off permanently.
INSTRUCTIONS FOR USE:
BEFORE USE:
-Make sure that all products’ packaging has
been removed.
-Some parts of the appliance have been
lightly greased. Consequently, the first time
the appliance is used a light smoke may be
detected. After a short time, this smoke will
disappear.
- To eliminate the smell given off by the
appliance when used for the first time, it is
recommended to have it on at full power for 2
hours in a well-ventilated room.
USE:
-Extend the cable completely before plugging
it in.
-Connect the appliance to the mains.
-
Guide the appliance to direct the flow of air in
the desired direction.
-Turn the appliance on, by turning the function
and heat intensity knob (A) to the desired
function.
-Turn the thermostat control knob (B) to the
desired temperature position.
-The pilot light (C) comes on.
FAN FUNCTION:
-Select the fan position.
HEATER FUNCTION:
-Select the desired heating power.
-Check that the thermostat control is set to the
temperature required.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
-Select the minimum position using the
thermostat control knob (B).
-Stop the appliance, selecting position 0 on
the function and heat intensity knob (A).
-Unplug the appliance from the mains.
-Clean the appliance.
CARRY HANDLE/S:
-This appliance has a handle on the back to
make it easy and convenient to transport (D).