EN
- Wait Until the pilot light coffee outlet (E) is also
highlighted. This situation indicates that the
water has reached the right temperature.
- Place A container under the nozzle.
- Open The steam control (Q), turning him to the
left, counterclockwise
- Press The button coffee /water outlet (G)
- The Hot water began to come out of the
vaporizer. ‘Once obtained the desired amount
of hot water, press the coffee outlet button,
which stops the pump
- Close The turning knob (Q) to the right,
clockwise Obtaining steam:
- The steam is used to foam milk for cappuccino,
and also to heat other liquids.
- Turn the appliance on using the on/off switch
- Wait until the pilot light has gone out which will
indicate that the appliance has reached an
adequate temperature.
- Press the heating button and continue heating
until the steam temperature has been reached.
the Warning light (E) will illuminate indicating
that the water has reached the necessary
temperature for generating steam.
- Place a recipient under the steam tube.
- Open Steam knob (Q) anticlockwise
- Steam only will begin to exit.
- When you have enough, close the control (Q)
and remove the recipient.
AUTO-OFF FEATURE:
- To that end, after 25 minutes, the unit switches
to energy saving mode.
- To return to normal operation you should just
march off-connect button (F).
- If Coffee stop half done, simply return to normal
operation, switching off and ON-OFF switch
(F). Once you have finished using the
appliance:
- Turn the appliance off, using the on/off switch
to OFF.
- Unplug the appliance to the mains.
- Remove the water from the water tank.
- Clean the appliance.
CLEANING
- Disconnect the appliance from the mains and
let it cool before undertaking any cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- It is advisable to clean the appliance regularly
and remove any food remains.
- If the appliance is not in good condition of
cleanliness, its surface may degrade and
inexorably affect the duration of the appliance’s
useful life and could become unsafe to use.
- After washing, dry all the parts before fitting
them together and storing.
HOW TO DEAL WITH LIME SCALE
INCRUSTATIONS:
- For the appliance to work correctly it should be
kept free of lime scale or magnesium
incrustations caused by the use of hard water.
- To prevent this kind of problem, we
recommend the use of water with low lime or
magnesium mineralisation.
- However, if it is not possible to use the kind of
water recommended above, you should
periodically remove the lime scale from the
appliance:
-
Every 6 weeks if the water is “very hard”.
-
Every 12 weeks if the water is “hard”.
- To do so, we recommend the use of the
specific product Taurus Decal, which can be
found in specialised shops and authorised
technical services.
- Homemade solutions are not recommended in
the descaling of this appliance, such as the use
of vinegar.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
support service if problems arise. Do not try to
dismantle or repair without assistance, as this
may be dangerous.
- If the connection to the mains has been
damaged, it must be replaced and you should
proceed as you would in the case of damage.
- If you detect any anomalies, refer to the
following table:
11