Sola ARES-2713, Starting Manual, Page: 23 / 40

23
7.7 HYDRAULIC TRACK MARKERS
Track discs can be orientated to achieve the correct penetra-
tion angle and their supporters are extensible in order to be
correctly adjusted.
LENGTH
(horizontal spacing between disk and external tine
coulter).
ORIENTATION
(attack angle).
HIGH PRESSURE OIL MAY ESCAPE, PASS
THROUGH THE SKIN AND INGRESS INTO THE
BODY, CAUSING SERIOUS INJURIES. KEEP HY-
DRAULIC HOSE LINES IN GOOD CONDITION.
NEVER STAND UNDER THE TRACK DISCS OR
WITHIN THEIR OPERATIONAL AREA.
IT IS ESSENTIAL TO FOLD THE TRACK MARK-
ERS BEFORE FOLDING THE MACHINE FOR
TRANSIT.
7.7.1
ADJUSTING TRACK MARKER’S LENGTH
To calculate the horizontal spacing between track discs and
the last lateral tine coulter, use following formula:
A x (number of tine co 1) - C
B=
2
A
= distance between tine coulters
B
= horizontal distance between track disc and the the last
lateral tine coulter.
C
= track width of the tractor.
PERFORM THE CALCULATION USING MEAS-
UREMENTS IN CENTIMETRES.
To adjust the distance of the track disc, proceed as following:
1-
Loosen the 2 nuts (1).
2-
Place track disc at the distance
B
previously calculated.
B = DISTANCE BETWEEN THE TRACK DISC AND
THE LAST LATERAL TINE COULTER.
3-
Tight the 2 nuts (1) after finishing these operations.
1
7.7.2 ADJUSTING TRACK MARKER’S INCLI-
NATION
To adjust the orientation of the track discs, proceed as following:
1-
Loosen the nut (2)
2-
Adjust track disc’s inclination so the disc has the desirable im-
pact on the ground.
3-
Tight the nut (2) after finishing these operations.
2
IT IS NOT RECOMMENDED TO INCLINE THE
TRACK DISCS TOO MUCH THUS PREVENTING
SERIOUS DAMAGE TO THE MACHINE.