18
| 2.0 Installation
2.4.2 Rack Installation
NOTES:
•
When the S4K2U-5C is installed in a rack, it must be supported by a shelf, brackets, or slide rails on each side. The
factory-supplied ears cannot support the weight of the UPS. They are used to move the UPS into and out of the rack
and to attach the UPS to the rack.
•
Mounting hardware and slide rails are sold separately. Contact your local SolaHD representative for these options.
To install a S4K2U-5C in a rack:
1.
Unpack the two bracket assemblies and mounting hardware from the rack-mounting kit (P/N: SRS1832). Bracket
assembly includes inner member and front and rear members. They are interchangeable between left-hand or right-
hand. Mounting hardware includes M4 screws and M5 screws.
2.
Remove inner member of each bracket assembly by extending it to its outermost position, depressing the retaining
latch and then pulling inner member from bracket assembly (see Figure 8).
Inner member
Bracket assembly
Pul
l ou
t
Retaining latch
Figure 8: Pulling inner member from each bracket assembly
3.
Determine the S4K2U-5C’s mounting position inside the racks vertical rails.
!
CAUTION
Install the S4K2U-5C as low as possible in the rack to reduce the risk of tipping.
4.
Attach the rear member of each bracket assembly to the rack’s rails with two factory-supplied M5 screws (see Figure 9).
M5 screw (4 pcs)
Vertical pole
Rear member
Front member
Figure 9: Installing rear member of each bracket assembly
