April 22
nd
, 2022 14
Mounting the Sol-Ark
A.
Keeping in mind Sol-Ark’s dimensions, find a suitable location for the system(s)
B.
NEMA 3R rating for Outdoor installations
C.
PROTECT the LCD screen from excessive UV exposure
D.
System weight = 76.1 lbs (34.5 kg). Securely attach to the wall. Affix a mounting board to studs using 6-8 screws
E.
Use 2-3 washers (choose screw length and surface type) to mount the Sol-Ark to the board/wall
F.
Mount Sol-Ark on the board/wall and ensure Sol-Ark is level
G.
Add two screws for the bottom mount
Integrating Batteries
(Sol-Ark POWERED “OFF”)
Install a separate DC over-current protector or disconnect device between the battery and the inverter for safe
operation and compliance. Switching devices may not be necessary for some applications, but over-current protectors
are still needed. We recommend that you use 1/0 AWG wire size.
A.
Please choose a suitable battery cable with the correct connector that fits well into the battery terminals (M10)
B.
Use a suitable screwdriver to unscrew the bolts and fit the battery connectors in, then fasten the bolt by the
screwdriver, make sure the bolts are tightened with a clockwise torque of 24.5 N.M
C.
Connect batteries to Sol-Ark as
shown in
Fig. B
below
D.
Install included
toroids (Part e. on pg.
4) on battery input
cables as shown in
Fig.
A
to the right
Fig. A
Do NOT reverse
polarity of batteries!
Damage will occur!
Summary of Contents for L12K-Tr
