EtherNet/IP Gateways - User Guide
8
Version EN-062020-1.00
2.3
Supported features
The EtherNet/IP Gateway supports the following features:
Simple connection to PROFIBUS PA and PROFIBUS DP slaves
Integration in FDT frame applications
Configuration of the gateway in a web browser
Integrated configurator to start up the PROFIBUS slaves
Access to process values of PROFIBUS slaves (input and output) in the Ethernet/IP control program
Read access to status information of the PROFIBUS slaves in the Ethernet/IP control program
Changing of operation state of the PROFIBUS master (STOP/RUN) in the Ethernet/IP control program
Detailed display of the status by LEDs
Two Ethernet interfaces (switched internally)
Power supply by connectors or rail connectors
2.4
System requirements
This gateway can be used in combination with an EtherNet/IP engineering system such as Rockwell Studio
5000 or Emerson DeltaV. When the gateway is used to parametrize PROFIBUS devices you need a Siemens
SIMATIC PDM or an FDT frame application like PACTware. Also required are:
24V power supply
one power conditioner per PROFIBUS PA segment
field barrier (for Ex environment)
PC with web browser
GSD file for each PROFIBUS device on your network
2.5
Safety precautions
CAUTION
During operation, the device's surface will be heated up. Avoid direct contact. When servicing,
turn off the power supply and wait until surface has cooled down.
Note
Do not open the housing of the EtherNet/IP Gateway. It does not contain any parts that need
to be maintained or repaired. In the event of a fault or defect, remove the device and return it
to the vendor. Opening the device will void the warranty!
