Softing Data Flow commModule MBP, Hardware Manual

Page: 18 / 36

commModule MBP - Hardware Manual
18
© Softing Industrial Automation GmbH
7
Special conditions for safe use
Please read and follow the instructions in this manual.
If the notes stated in this excerpt are not observed or in case of inappropriate handling of the device,
our liability is waived.
The details of this user manual have to be observed as have to be the conditions for use and the
applicable details stated on the marking, type labeling and accompanying documentation of each device.
The device is only approved for intended and appropriate use. In case of non-compliance, the warranty
and manufacturer’s liability do no longer apply!
It has to be ensured that only such equipment is installed which complies with the types of protection
applicable to the relevant zones!
All connected electrical equipment has to be suitable for the respective intended use.
Equipment Protection Level Ga requires an enclosure according to IEC 60079-0. Mechanical strength tests
on enclosures, e.g. degree of protection (IP), thermal endurance tests, impact test, fall test are not
applicable for the commModule MBP as a bare module.
7.1 Galvanic isolation
The circuits of the commModule MBP have no galvanic isolation. All signals are galvanically connected
together.
7.2 Safety block diagram
The following block diagram shows the commModule MBP: