Page: 3
CAN Status LED
Status
off
no power or in reset state
flashing green
in initialization state
solid green
CAN started
flashing red
CAN error passive
solid red
CAN bus off
USB Status LED
Status
off
no power or not recognized
solid green
connected and recognized
solid red
not (yet) recognized or
error
2 CAN Connector Pin Assignment
Connector pinning complies to CiA standard DS 102.
Pinning of the 9 pin
D-Sub
connector
3 Status
LEDs
There are status LEDs for CAN and USB that show the current status.
4 CE
Information
This device complies with the requirements of the EC directive 2004/108/EC
"Electromagnetic Compatibility" (EMC directive).
The product meets the following requirements:
•
Emission: EN61000-6-4 Generic emission Standard (industrial environments)
EN55022 Class A (ITE Product Standard)
EN55011 Group1 Class A (ISM Product Standard)
•
Immunity: EN61000-6-2 Generic Immunity Standard (industrial environments)
A "Declaration of Conformity" in accordance with the above standards has been made and is
filed at Softing Industrial Automation GmbH, Germany.
NOTE:
•
To satisfy the EMC requirements, the equipment used (PC, monitor, CAN stations, etc.)
also has to meet the EMC requirements. A shielded cable must be used. In addition, the
cable shield must be grounded properly.
Warning!
: This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
5 RoHS
Information
CANpro USB is RoHS compliant.
Pin Signal
1 N.C.
2 CAN_L
3
Isolated GND
4 N.C.
5
Drain connected to connector
shield (1M/2.2n to isolated GND)
6 Isolated
GND
7 CAN_H
8 N.C.
9 N.C.
