copyright by www.soflow.com
12
Hook in brake cable
After unfolding your SO1 PRO, you need to hook the brake cable for the rear disc brake to the hook and to the brake lever. Now route the brake cable along the handlebar through the guide to
the brake lever. Now tighten the brake lever and fix the end of the cable in the slot of the brake lever and push the cable forward into the lever. If the connection has been adjusted too tightly
and cannot slide to the front end of the brake lever, then the brake mechanism must be adjusted (See Brake Adjustment).
Adjusting the disc brake
If the brakes are too tight, use a 5mm Allen wrench to loosen the screw of the pressure plate by turning anticlockwise.
Shorten the length of the brake wire to loosen the brakes, then tighten the screw again. If the brakes are too loose,
loosen the screw and pull the brake wire to extend the wire, then tighten the screw again.
Note
: You can find more instructions and tips and tricks on Youtube.com under SoFlow.
To pump up the tyres
If the tyres start to lose pressure or have too little air in them from the start, you should inflate them to 2.5 bar.
