Soehnle Professional 6808, Operating Instructions Manual

Page: 25 / 64

25
ENGLISH
7. Troubleshooting
Display /
Indices
Probable causes Remedy
Ad
¯¯¯
Load cell wires to indicator are
incorrectly connected, or
shorted, or opened; or ADC,
load cell are damaged
Make sure wires are ok and
correctly connected.
Replace load cell or ADC
chip. Service required.
Ad___
0
¯¯¯
Weight reading exceeds Power
On Zero limit.
Make sure scale platform is
empty.
Perform zero calibration.
0___
Weight reading below Power On
Zero limit.
Install platform on scale.
Perform zero calibration.
¯¯¯¯
Weight reading exceeds
overload limit, or The weight
value cannot be displayed in the
current unit of measure
because it exceeds 6 digits
Reduce load on scale until
weight value can be
displayed. Use a more
appropriate unit of measure.
Contact your local dealer or
supplier for a new set up
____
Weight reading below under
load limit.
Install platform on scale.
Perform zero calibration
EEP.E1
CONFIG or CAL parameters are
not correctly set
Contact your local dealer or
supplier for a new set up
EEP.E2
USER parameter is not correctly
set
Contact your local dealer or
supplier for a new set up
CAP.ER
Capacity parameters are not
correct
Contact your local dealer or
supplier for a new set up
CAL.Er
Calibration error, maybe input
data or loaded weight is too
small, too big, unstable,
un-linear
Input correct data, load
correct weight onto
platform, Service required
Scale does not
turn on
Power cord not plugged in or
properly connected. Power
outlet not supplying electricity.
Battery discharged.
Other failure
Check power cord
connections. Make sure
power cord is plugged into
the power outlet. Check
power source. Replace
batteries.
Service required.
Scale can‘t set
to zero or won‘t
zero when
turned on
Load on scale exceeds
allowable limits.
Load on scale is not stable.
Load cell damage.
Remove load on scale.
Wait for load to become
stable.
Service required.
„Empty battery“
symbol /
Lo.bAt
Batteries are discharged. Charge batteries.