socomec DIRIS B-30 RF, User Manual, Page: 37 / 62

37 EN
7. STATUS AND AUTO-ADDRESSING LEDS
7.1. Status LEDs
%6"G"')!"$&X'$&!6"!"&06$'*#
The addressing button is used to automatically assign a Modbus address from the gateway.
Power supply
Addressing button
Alarm
Metrology
RS communication
G" Fixed Blinking Pulse
ON
In operation "&'$"&'@!"
Modbus control to identify the
$Q#&"'OW 1 second to start-up
/ALARM
E'#Q&+,'&+!OW
"Q:"(&*06"
setup alarm at the same time) E"&'"!(#"
Q!'"'"&$"&''$O],
'&&#()OW 1 second to start-up
COM
Addressing problem. E$$""Ž 1 second to start-up and when a
0#$"(&""$
- - &"(&'$"&6#&&+
pulse weight
7.2. Auto-addressing
Auto-addressing mode is used to automatically allocate addresses to products connected to the gateway. This
mode is only compatible with DIRIS B-30 and Digiware type PMDs. The addresses will be allocated manually on the
&6{QEW'$#"Q;?%W
%9&#&$")Y
ZMode 1 - Auto-detection and automatic addressing
ZMode 2 - Auto-detection and address selection
&$"96&!_'@!(#'Q"$"(&')&9W
&$"$&!0&#{@!(($96"*&'X+%6"#&$"$")$'6"*&'X+#'!