18
EN
ATYS D10 / D20 - 542359B - SOCOMEC
7. Operation Modes (Control or test) ATyS D20
It is possible to start test sequences or to electrically control the changeover switch from the ATyS D20 keypad.
7.1. Browsing
>
Enter Control or Test modes
• Step 1: Press the "mode" push button until Control or Test led is blinking
•
Step 2:
Press "validate"; the Control or Test LED then becomes fixed
CONTROL MODE
Access code is displayed
TEST
MODE
It is possible to test the LEDs and LCD without entering any code by pressing
Test on load or test off load access codes are displayed after pressing
or
Enter the access code (0000) using the "left", "right", "up" and "down"
buttons
Press "validate" .
7.2. Operation Modes (Control or test)
>
Exit control or test modes
Press "ESC" push button
Return to any active mode (Automatic or Manual) depends on information from the master ATyS device .
>
Use of Control or Test modes
To run a test, press buttons
and
To electrically switch positions, press buttons
,
and
.
Summary of Contents for ATyS D10
Page 11: ...11 EN ATYS D10 D20 542359B SOCOMEC 2 2 2 2 3 2 3 2 3 4...
Page 12: ...12 EN ATYS D10 D20 542359B SOCOMEC 5 2 2 2 Architecture valid for ATyS M 6e master...
Page 16: ...16 EN ATYS D10 D20 542359B SOCOMEC 5 2 2 4 Architecture valid for ATyS C30 master...
