1/4“ x 13/4”
Special instructions for mounting on wooden surface:
1. Screw two Hex nuts (1/4”-20 thread, not included) onto the
machine-threaded portion of the Hanger Bolt.
2. Use an open-ended wrench to lock the nuts against each other.
3. Drill a pilot hole into the surface you wish to place the
Charging Mount.
4. Thread the lag portion of the Hanger Bolt into this surface as far
as you can by hand.
5. Use a wrench on the outermost nut to drive the Hanger Bolt into
the surface.
6. When the lag portion is sufficiently threaded, unjam the two
nuts from each other, and run them off (unscrew them).
Instructions for Mounting on wooden surface
13
