4. Product usage (SNT-WL22BT)
4.1 How to use the lighting
0-225°
adjustable
4.2 How to use the Bluetooth speaker
•
In the case that power is on, long press "BT" button to turn on the Bluetooth with the
warning tone. Then turn on the Bluetooth on your mobile device and search for Bluetooth
name of "WL30BT". Connect Bluetooth with short “beep”, and the music (Internet
Radio) can be played immediately.
•
The volume can be adjusted by the volume keys on the phone or by the pressing buttons
"+" and "-" on the lamp. Also, the “
” can pause the play of Bluetooth.
•
Turning off the Bluetooth on the phone can terminate the connection. Only when the first
device exits can a second device be connected.
•
After pressing the "BT" button, if it has not been connected to a Bluetooth device within
five minutes, the work lamp will automatically turn off the Bluetooth function with warning
A
B
C
D
ON
OFF
Audio system
Please firmly insert the
plug into a live socket.
The improper contact
between the plug and
socket would cause
the damage to the
equipment.
Press the button “DIM” when the switch is
“ON”, and adjust the brightness of LED
light board, which are respectively 2200 LM,
1200 LM and 300 LM, appeared in repetitive
cycle.
4.3 With waterproof socket (Figure A)
and waterproof USB charging
port (Figure B)
tone. Please long press the "BT" button again when using it. Long press “BT” button
can turn off the Bluetooth.
•
If the LED light is not needed during music playing, long press the “DIM” button to turn
off the light temporarily, and re-press “DIM” to activate the light again.
Figure A
Figure B
The switch will not control this socket .
When the power plug is inserted into the
external socket, the socket will be on the
work state all the time. USB charging port
will be under control of switch.
Angle can be adjusted as
per sketch, it can also be
used as a desk lamp when
it stays at 225
°
.
Press switch button "ON",
the LED light will be the
brightest at this time. And
when the switch is in
“OFF”, the LED light will
be switched off.
Instruction Manual
5. Precautions
Accessories
Base side
•
After opening the package, check the product to see if the product is complete, if there is obvious damage or
alteration and if the accessories are complete.
•
Please keep the packaging waste away from children for there may exist the danger of choking.
•
Please do not disassemble the part of the working light in order to avoid damaging the product.
•
When rotating the light board do not put forth too much strength so as not to damage the rotary joint.
•
When the distance between the work light and socket is more than 1.8M, please use an extension socket, where
the extension cords grade must be equal to or higher than the grade of the power cable rating, otherwise it will
lead to hazardous accidents.
•
Do not look directly into the LED light board for a long time, for doing so may cause damage to vision.
•
After completing USB charging, please fully cover the waterproof cap.
4.4 How to use the accessories and fixing plate
Accessories
Base side
3.4 How to use the accessories and fixing plate
Instruction Manual
6.1 LED is not lit after the switch is turned on.
•
Please check whether the plug is fully inserted into the socket.
6.2 The light is too dark or too bright.
•
Please check up 3.1.C and adjust the required brightness.
6. Troubleshooting
