X
XX
Maintenance
Maintenance schedule
Once a year:
Each time before the start of the season or after season ends:
Adjust the skids (for 5.5HP,
6.5HP, 9.0HP and 11HP)
Adjust clearing Plate
(For 4HP)
Have the machine checked over and maintained by our service department.
•
•
Check the oil level and top up as necessary.
Check all screw fittings for firm seating, tighten them if necessary.
Check the safety features.
(2) and wheels (3) must be touching the
ground at the same time. If the clearing
plate is set too high, snow will be hurled
backwards. If it is too low it will be worn
down faster.
To set the clearing plate:
Figure 7
Figure A
After
use
Maintenance tasks
Clean throw-out chute, warm and
warm casing
Check tire pressure, increase as
required
Check coupling adjustment,
re-adjust as required
Have the carburetor setting
checked
Inspect the clearing plate, replace
worn-out clearing plate
Check skids replace worn-out skids
in pairs
Check caterpillar track, readjust as
required. Replace defective
caterpillar track
Clean sir cooling system and
exhaust
2)
Replace air filter
1)
Clean spark plug
1)
Change oil
3)
Clean air filter
Lubricate mobile and rotating parts
Replace fuel filler cap
Have exhaust silencer replaced
2)
See “Engine instructions”
Have this work carried out only by our service department
First oil change after 5 hours
10
hours
100
hours
End of
season
As
required
25
hours
50
hours
For small to moderate amounts of
snow and terrain that includes many
curves, the connection between right
wheel and driver can be disconnected.
The machine is easier to steer.
For larger amounts of snow and
iced-over paths, both wheels must
be driven.
Line up hole (2) of the wheel hub
and the hole of the wheel axle.
Insert ring spring (1) both holes
(2). The wheel may not be fixed
through the hole (3).
When the machine is starting on even
ground, the worm (1), clearing plate
--Fasten the skids with nuts (2) in such a
way that they uniformly touch the
With the skids (1), the distance between
the ground and the clearing plate (5) can
be set in such a way that no parts of the
ground (e.g. earth or stones) can be
taken up.
(machine with caterpillar dirve) set
setting lever ( Figure 4, item 1) to
position II
Loosen nuts (2) on both sides of
the machine.
Adjust skids to conform to the ground
distance:
-- Lower for uneven or non-hard
surfaced paths.
Higher for even paths.
Move the ring spring (1) to outer
hole (3)
Tip the machine backwards.
Loosen the nuts (5).
Set the clearing plate lower or higher
as appropriate and tighten nuts
again.
Tip the machine forward again, check
the setting and repeat as necessary.
19
4
