3
Some Bubble Master liquids may leave permanent marks on clothing. Refer
to specific Bubble Master liquid use instructions for details.
Pay attention to all warning labels and instructions printed on the exterior
of your SnowMasters Special Effects Bubble Machine.
Unpacking & Inspection
Open the shipping carton and check that all equipment necessary to operate the
system has arrived intact. In addition to the SnowMasters Special Effects
Bubble Machine, you should receive the following items:
1. This user manual.
2. One mounting bracket.
3. Remote control and radio receiver.
Before beginning initial setup of your SnowMasters Special Effects Bubble
Machine, make sure that there is no evident damage caused by
transportation.
In the event that the unit’s housing or cable is damaged, do not plug it in and
do not attempt to use it until after contacting your dealer for assistance.
Setup
Remove all packing materials from the bubble machine.
Place bubble machine on a flat surface.
Loosen the side screws and lift the housing upwards. You will see a liquid
tank.
Pour bubble liquid into the liquid tank, being careful not to exceed the
maximum fluid level. DO NOT OVERFILL.
When the container is full, lower the housing and tighten the screws.
IMPORTANT SAFETY NOTICE:
Ensure your bubble machine is unplugged from the main electrical supply before
attempting to open the housing.
To help avoid accidental exposure to dangerous live AC main voltage, two safety
screws are fitted that require a screwdriver to remove. Once these are removed,
the finger screws can be undone by hand (see photo above).
Once the screws are removed, the lid of the housing can be carefully swung
upwards, as shown above. Take care not to spill any of the bubble fluid inside
the unit.
