10
Maintenance
To order genuine replacement parts or accessories for the
Sun Joe
®
SWD2500 electric wet/dry vacuum, please visit
sunjoe.com
or contact the Snow Joe
®
+ Sun Joe
®
customer
service center at 1-866-SNOWJOE (1-866-766-9563).
m
WARNING!
Disconnect the power cord before
performing any maintenance task.
If the power is still connected, the unit could be accidentally
turned on while you are performing maintenance on it, which
could result in personal injury
.
Cleaning The Dust Tank
Clean the equipment routinely after each use:
1. Take the unit outside to clean it to avoid creating a
mess indoors.
2. Remove the power head and empty the dust tank. Clean
the tank with water and allow it to dry completely.
Cleaning the Cloth Filter
m
WARNING!
To avoid serious personal injury, always
turn the unit off and unplug it before cleaning or servicing.
The cloth filter included is made of high quality material
designed to stop small dust particles. The filter should be used
for dry pick-up only. If the dust filter is wet, it will clog quickly
and be very difficult to clean. Handle the filter carefully when
removing it for cleaning and replacing. Check the filters for
tears or small holes, a small hole can let dust pass through
and out of the cleaner. Do not use a filter with holes or tears,
replace it immediately.
1.
Switch off and unplug the unit.
2. Remove the power head from the collection tank.
3. With the removed power head in the upside down
position, slide the filter locking ring up and remove it. Then
carefully remove the cloth filter from the filter cage
(Fig. 9).
4.
Clean the cloth filter by gently tapping or brushing dirt off.
Cleaning should not be done indoors in living areas.
5. If needed, use a mild soap and water solution to wash the
cloth filter and rinse with clean water. Allow the wet filter
to air dry for 24 hours before installing onto the filter cage.
Cleaning the Foam Filter
m
WARNING!
The foam filter must be cleaned every time
after wet vacuuming.
1.
Switch off and unplug the unit.
2. Remove the power head from the collection tank.
3. With the removed power head in the upside down
position, carefully remove the foam filter from the filter
cage (Fig. 10).
NOTE:
The foam filter can be attached to the filter cage
securely. The filter locking ring is not needed when only
the foam filter is attached.
4.
Use a mild soap and water solution to wash the foam filter
and rinse with clean water. Allow the wet filter to air dry for
24 hours before installing onto the filter cage.
5.
To assemble the filters, first fit the foam filter on the filter
cage, then fit the cloth filter over the outside of the foam
filter. Last, slide the filter locking ring down, and press
(Fig. 11).
Fig. 9
Cloth filter
Filter locking
ring
Fig. 10
Foam filter
Fig. 11
Cloth filter
Filter locking
ring
Foam filter
