7
Lubrication
The bearings in the sweeper have been pre-lubricated at
the factory. However it’s recommended that a few drops of
light oil should be added to the brush shaft bearings twice a
year. Also, the gear should be cleaned every two years. After
cleaning apply an even coat of light grease.
1.
Use a screw driver to pop off the hub cap (Fig. 12).
2.
To remove the wheel, take out the circlip and the flat
washer; you will see the gear and the shaft (Fig. 13).
3.
Remove the circlip on the gear, the gear can be taken off
easily (Fig. 14).
4. Clean the gear and lubricate the shaft as needed, then
reassemble the wheel in a reverse sequence.
Fig. 12
Hub cap
Fig. 13
Circlip
Flat washer
Wheel
Gear
Shaft
Fig. 14
Circlip
Gear
Summary of Contents for SUNJOE SJSW26M-RM
Page 10: ...10 NOTES ...
Page 12: ...snowjoe com ...
