3
Unpacking
Carton Contents
•
Spreader
•
Handle
•
Handle support (x2)
•
Control rod
•
Stand
•
Hopper screen
•
Cover
•
M6x45 carriage bolt (x2)
•
M6x40 carriage bolt (x6)
•
M6x16 hex bolt (x2)
•
Curved washer (x8)
•
Nylon washer (x2)
•
M6 lock nut (x10)
•
M10/M13 wrench
•
M10/M14 wrench
•
Manual with registration card
1.
Carefully remove the spreader and check to see that all of
the above items are supplied.
2.
Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Instead,
please call the Snow Joe
®
+ Sun Joe
®
customer service
center at 1‑866‑SNOWJOE (1‑866‑766‑9563).
NOTE:
Do not discard the shipping carton and packaging
materials until you are ready to use the spreader. The
packaging is made of recyclable materials. Properly dispose
of these materials in accordance with local regulations or
save the packaging for long‑term product storage.
IMPORTANT!
The equipment and packaging materials are not
toys. Do not let children play with plastic bags, foils, or small
parts. These items can be swallowed and pose a suffocation
risk!
Assembly
Use the two provided wrenches to tighten the nuts and bolts.
1.
Turn the spreader upside down.
2.
Install the stand onto the frame of the spreader using two
sets of M6x40 carriage bolts, curved washers and lock nuts
as shown (Fig. 1).
3.
Install one of the handle supports onto the frame of the
spreader using two sets of M6x40 carriage bolts, curved
washers and lock nuts. Do the same for the other side
(Fig 2).
NOTE:
Do not tighten the lock nuts yet.
4.
Turn the spreader right side up.
5.
Slide the end of the handle between the two handle
supports and fix it in place using two sets of M6x45
carriage bolts, curved washers and lock nuts (Fig. 3).
Fig. 1
Stand
M6x40
carriage
bolt
Curved
washer
Lock nut
Fig. 2
Handle
support
Curved
washer
Lock nut
M6x40
carriage bolt
Fig. 3
Handle
Curved washer
Lock nut
M6x45
carriage bolt
