9
2. Check that the mains voltage is the same as that marked
on the rating plate of the quick charger. Then, plug the
charger adapter into an appropriate AC power outlet
(Fig. 2).
3. Place the battery pack into the charger by sliding the
pack as shown to lock it into position. When you insert
the battery into the charger, the bottom red light on
the charger will illuminate to indicate that the battery is
charging
(Fig. 3).
4.
The battery indicator LEDs will twinkle and illuminate one
by one during the charging process. When the 3 LEDs are
all illuminated green and the green LED on the charger
is on, the battery is fully charged. Unplug the charger
immediately (Fig.
3)
.
5.
The battery will take approximately 2 hours 20 minutes
to charge. The charge indicator LED will become green
when the battery is fully charged, unplug the charger
immediately when the green light is on.
m
CAUTION!
FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet first, then disconnect the charger from the battery
m
WARNING!
This charger does not automatically turn off
when the battery is fully charged. Please take care not to leave
the battery plugged into the charger. Switch off or unplug the
charger at the mains when charging is complete.
4.
Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT!
Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
Assembly
m
WARNING!
Do not insert the safety key until assembly
is complete. Failure to comply could result in accidental
starting and serious personal injury.
m
WARNING!
Before performing any maintenance,
make sure the key is removed from the unit. Failure to heed
this warning could result in serious personal injury.
m
WARNING!
The product must be fully assembled
before operation. Do not use a product that is only partially
assembled or assembled with damaged parts.
NOTE: Before using the mower, follow these instructions to
assemble the handle and grass bag.
Handle Assembly
1. Fit the lower handle frame into the two holes in the
machine body and fasten the handle on both sides with
the screws provided (Fig. 4).
R
Fig. 1
Battery
compartment
cover
Push lock
button
green
Power on
Fig. 2
Fig. 3
red
Charging
green
Fully charged
Fig. 4
Machine body
Screw
Lower handle
frame
