background image

5

•  Store your battery pack and charger in a cool, dry 

place –

 

Do not store the battery pack or charger where 

temperatures may exceed 104ºF (40ºC), such as in direct 

sunlight or inside a vehicle or metal building during the 

summer.

Protection from environmental influences

1.  Wear suitable work clothes. Wear safety goggles.
2.  Protect your cordless tool and the battery charger  

from moisture and rain. Moisture and rain can cause 

dangerous cell damage.

3.  Do not use the cordless tool or the battery charger near 

vapors and flammable liquids.

4.  Use the battery charger and cordless tools only in dry 

conditions and at an ambient temperature of 50°F – 104°F 

(10°C – 40°C).

5.  Do not keep the battery charger in places where the 

temperature is liable to reach over 104°F (40°C). In 

particular, do not leave the battery charger in a car that is 

parked in the sunshine.

6.  Protect batteries from overheating. Overloads, 

overcharging and exposure to direct sunlight will result 

in overheating and cell damage. Never charge or work 

with batteries that have been overheated – replace them 

immediately, if possible.

7.  Store the charger and your cordless tool only in dry 

locations with an ambient temperature of 50°F – 104°F  

(10°C – 40°C). Store your lithium-ion battery pack in a 

cool, dry place at a temperature of 50°F – 68°F  

(10° – 20°C). Protect the battery pack, charger and 

cordless tool from humidity and direct sunlight. Only  

place fully charged batteries in storage (charged to  

at least 40%).

8.  Prevent the lithium-ion battery pack from freezing. Battery 

packs that were stored below 32°F (0°C) for more than  

60 minutes must be discarded.

9.  When handling batteries, be wary of electrostatic 

charge. Electrostatic discharges can damage the 

electronic protection system and the battery cells. Avoid 

electrostatic charging and never touch the battery poles.

Information about the battery

1.  The battery packs (model iON100V-2.5AMP or  

iON100V-5AMP) must be purchased separately for 

use with this cordless hedge trimmer are only partially 

charged. The battery packs have to be charged 

completely before you use the tool for the first time.

2.  For optimum battery performance, avoid low discharge 

cycles by charging the battery packs frequently.

3.  Store the battery packs in a cool place, ideally at 59°F 

(15°C) and charged to at least 40%.

4.  Lithium-ion batteries are subject to a natural aging 

process. The battery packs must be replaced at the latest 

when its capacity falls to just 80% of its capacity when 

new. Weakened cells in an aged battery packs are no 

longer capable of meeting the high power requirements 

needed for the proper operation of your cordless hedge 

trimmer, and therefore pose a safety risk.

5.  Do not throw battery packs into an open fire as this poses 

a risk of explosion.

6.  Do not ignite the battery packs or expose them to fire.
7.  Do not exhaustively discharge batteries. Exhaustive 

discharge will damage the battery cells. The most 

common cause of exhaustive discharge is lengthy 

storage or non-use of partially discharged batteries. Stop 

working as soon as the performance of the batteries falls 

noticeably or the electronic protection system triggers. 

Place the battery packs in long-term storage only after 

they have been fully charged.

8.  Protect batteries and the tool from overloads. Overloads 

will quickly result in overheating and cell damage inside 

the battery housing even if this overheating is not 

apparent externally.

9.  Avoid damage and shocks. Immediately replace batteries 

that have been dropped from a height of more than one 

meter or those that have been exposed to violent shocks, 

even if the housing of the battery pack appears to be 

undamaged. The battery cells inside the battery may have 

suffered serious damage. In such instances, please read 

the waste disposal information for proper battery disposal.

10. If the battery pack suffers overloading and overheating, 

the integrated protective cutoff will switch off the 

equipment for safety reasons. If this situation happens, 

stop the tool and let the battery cool down for a few 

minutes before restarting. 

11. Use only original battery packs. The use of other batteries 

poses a fire risk and may result in injuries or an explosion.

Information about the charger and the 

charging process

1.  Please check the data marked on the rating plate of the 

battery charger (sold separately). Be sure to connect the 

battery charger to a power supply with the voltage  

marked on the rating plate. Never connect it to a different 

mains voltage.

2.  Protect the battery charger and its cord from damage. 

Keep the charger and its cord away from heat, oil and 

sharp edges. Have damaged cords repaired without delay 

by a qualified technician at an authorized Snow Joe

®

 +  

Sun Joe

®

 dealer or call the Snow Joe

®

 + Sun Joe

®

 

customer service center at 1-866-SNOWJOE  

(1-866-766-9563).

Summary of Contents for Sunjoe iON100V-24HT-CT-RM





















Reviews: