9
torn. Do not use filters that are broken or torn. Handle the
filters carefully when removing and installing.
• To reduce the risk of hearing loss associated with sound
level(s), hearing protection is required.
• Always direct the cord backwards, away from the unit.
• This unit is intended for indoor use only. Do not use this
unit outdoors.
• Be extremely careful when working on slopes and stairs.
• Always move forward by walking. Never run.
• Clean up after using the wet/dry vacuum. Dispose of
debris appropriately.
• Always use the handle for transporting the equipment.
m
WARNING!
To avoid personal injury, wear ear
protectors when operating this unit. Wear a face mask or dust
mask in dusty locations.
Air Inlet
Never cover the air inlets. Keep them free from obstructions
and debris. They must always remain clear for proper motor
cooling.
m
WARNING!
To avoid personal injury, do not wear loose
fitting clothing or articles such as scarves, necklaces, chains,
ties, etc., that could get drawn into the air inlet. To make sure
long hair does not get drawn into the air inlet, tie back long hair.
Basic Vacuum Procedures
m
WARNING!
Do not vacuum drywall dust, fireplace soot
or ash with the unit. This is very fine dust which will not be
captured by the filter and may cause damage to motor.
m
WARNING!
The cloth filter is only for dry vacuum. Make
sure the cloth filter is attached for dry cleaning, and DO NOT
use the cloth filter when vacuuming liquid.
m
WARNING!
The foam filter must be used for wet
vacuuming, and make sure to clean the foam filter after wet
vacuuming.
• Place the equipment on a level surface that is not heat
sensitive.
• Always use the vacuum hose for vacuuming. Hold the
vacuum hose at a distance of approximately 0.4 in. (1 cm)
above the material to be vacuumed.
m
WARNING!
When vacuuming large quantities of liquids,
do not immerse the brush attachment completely in the liquid;
leave a gap at the tip of the brush attachment opening to allow
air inflow. The machine is fitted with a float valve that stops the
suction action when the collection tank reaches its maximum
capacity. You will notice a decrease in motor speed. When this
happens, turn off the machine, disconnect from power supply,
and drain the liquid into a suitable receptacle or drain. To continue
vacuuming, refit the collection tank with the power head.
• To prevent overheating of the motor, stop the unit for one
minute after every 15 minutes of using.
• Turn off and unplug the unit after vacuuming, before
cleaning and maintenance. After wet vacuuming, empty
the collection tank, clean and dry the inside and outside
before storage.
• Empty the tank outside in order to avoid a mess.
• Clean or change the filters (see Maintenance section) if the
suction performance deteriorates.
m
WARNING!
Never remove the power head without
first turning the power switch to the OFF (O) position and
unplugging the unit from the main power source.
Releasing and Assembling the Power
Head
m
WARNING!
To prevent personal injury, make sure the
switch is in the OFF position and the unit is unplugged before
attaching or removing the power head.
1. To release the power head, grab the two lid locks and pull
outside to unlock. Then remove the power head
(Fig. 8).
2. To attach the power head, insert the tabs on each side of
the collection tank into the lid lock slots, and push firmly
to make sure the tabs are locked inside of the lid locks.
NOTE: The power head must be attached any time the
unit is being operated.
Fig. 8
Lid lock
Power head