10
m
CAUTION!
The washer must only be used with clean
water; use of unfiltered water containing corrosive chemicals
will damage the washer.
5.
Make sure the motor switch is pushed to the OFF (0)
position before plugging the unit into the power outlet.
Operation
m
IMPORTANT!
This pressure washer is equipped with
a micro-switch sensitive to water flow. This Total Stop System
(TSS) senses water flow in the pump. When the trigger is
released, water stops flowing through the pump. The TSS then
automatically turns the motor off to protect the pump from
overheating, thus saving energy and prolonging pump life.
1.
Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the pressure
washer rating plate. If the power supply is correct, you
may now plug the pressure washer into the power outlet
(Fig. 8).
NOTE:
The GFCI may need to be reset when first plugged
into the electric outlet. Press the "Reset" button until the
power light indicator on the GFCI illuminates.
2.
Position the washer as CLOSE as possible to the
water supply.
3.
The washer must be used on a secure and stable surface
in a standing, upright position (Fig. 9).
4.
Turn the water supply tap on completely.
5.
Unlock the safety lock, then press the trigger for a few
seconds until the water flow is steady. Operating the
pressure washer in this manner will allow air to escape and
discharge residual pressure in the hose (Fig. 10). Release
the trigger after all residual pressure is discharged.
6.
Keeping the trigger pressed, turn the switch to the ON (I)
position to start the pressure washer (Fig. 11).
7.
When re-starting the motor, always keep the trigger
pressed.
NOTE:
The motor only runs when the trigger is depressed
and shuts off when the trigger is released.
RESE
T
TEST
Fig. 8
GFCI
Power light
indicator
Reset
Fig. 9
RELEASE
Fig. 10
Trigger
Safety lock
Fig. 11
On/Off
switch
