14
Maintenance
To order genuine replacement parts or accessories for the Snow
Joe
®
iON18SB-PRO-RM cordless snow blower, please visit
snowjoe.com or contact the Snow Joe
®
+ Sun Joe
®
customer
service center at 1-866-SNOWJOE (1-866-766-9563).
m
WARNING!
Make sure to turn off the switch and
remove the battery before performing any maintenance task
on your snow blower.
Lifetime Lubrication (Motor + Auger)
Lubrication is not necessary and may damage the unit. The snow
blower is lubricated for lifetime use at the factory before shipment.
General Maintenance Tips
1. Do not attempt to repair the machine unless you have the
proper tools and instructions for disassembly and repair of
the machine.
2. Check bolts and screws at frequent intervals for proper
tightness to ensure that the equipment is in safe
working condition.
3.
After each snow removal session, run the snow
blower
for a few minutes to prevent the collector/impeller from
freezing. Shut off the motor, wait for all revolving parts
to stop
completely, and wipe residual ice and snow off
the unit.
Rotate the chute deflector by the remote switch
several times to remove any excess snow.
Proper Care for B Charger
m
WARNING!
To reduce the risk of injury, always unplug
the charger and remove the battery pack from the charger
before performing any maintenance task. Never disassemble
the battery pack or charger. Contact your Snow Joe
®
+
Sun Joe
®
dealer or the Snow Joe
®
+ Sun Joe
®
customer
service center for ALL repairs.
1.
To reduce the risk of injury and damage, never immerse
your battery pack or charger in liquid or allow any liquid to
flow inside these components.
2. Clean out dust and debris from charger vents and
electrical contacts by blowing with compressed air.
3. Use only mild soap on a damp cloth to clean the battery
pack and charger, keeping away from all electrical
contacts. Certain cleaning agents and solvents are
harmful to plastics and other insulated parts. Some of
these include gasoline, turpentine, lacquer thinner, paint
thinner, chlorinated cleaning solvents, ammonia and
household detergents containing ammonia. Never use
flammable or combustible solvents around battery packs,
battery chargers or tools.
4. The EcoSharp
®
iCHRG40 lithium-ion battery charger has
no serviceable parts.
Replacing the Rubber Plates
m
WARNING!
Make sure to turn off the switch and
remove the battery before performing any maintenance task
on your cordless snow blower.
NOTE:
When replacing worn rubber plates, pay close attention
to the order in which you remove the plates. Insert the new
plates in the reverse order.
1. Detach the worn rubber plate assembly by removing the 8
sets of nuts and bolts used to secure it (Fig
s.
20 & 21
).
2. Install the new rubber plate assembly by tightening the 8
sets of nuts and bolts on both sides (Fig.
20).
Fig. 20
Fig. 21
