8
Discharge Chute Assembly
1.
Lift the chute deflector until it locks securely into place on
the discharge chute.
2.
Raise or lower the chute deflector to the desired height of
the snow stream.
3.
Insert the washers into the middle of the chute connection,
pass the carriage bolts through from the inside of the
chute, and tighten with the deflector knobs on each side
(Figs. 5 & 6).
NOTE: Do not overtighten the knobs.
Battery Pack Operation
The equipment is powered by a lithium-ion battery. The battery
pack is completely sealed and maintenance free.
Battery Charge Level Indicator
The battery pack is equipped with a push button for checking
the charge level. Simply press the push button to read off the
battery charge level from the LEDs of the battery indicator:
• All 3 level monitoring LEDs are lit: Battery charge level
is high.
• 2 level monitoring LEDs are lit: Battery charge level is
decreasing. Stop work as soon as possible.
• 1 level monitoring LED is lit: Battery is flat. Stop work
IMMEDIATELY and charge the battery. Otherwise the
battery’s service life will be greatly shortened.
NOTE: If the charge level button does not appear to be
working, place the battery pack on the charger and charge as
needed.
NOTE:
Immediately after using the battery pack, the charge
level button may display a lower charge than it will if checked
a few minutes later. The battery cells “recover” some of their
charge after resting.
Charger Operation
m
WARNING!
Charge only the EcoSharp
®
iBAT40 or
the EcoSharp
®
PRO iBAT40XR lithium-ion battery packs
in compatible EcoSharp
®
iCHRG40 or EcoSharp
®
SWIFT
iCHRG40QC battery chargers. Other types of batteries may
cause personal injury and damage.
To reduce the risk of electric shock, do not allow water to flow
into the charger's AC/DC plug.
When to Charge Battery
NOTE: The EcoSharp
®
iBAT40 and EcoSharp
®
PRO iBAT40XR
lithium-ion battery packs do not develop a "memory" when
charged after only a partial discharge. Therefore, it is not
necessary to run down the battery pack before placing it into
the charger.
• Use the battery charge indicator lights to determine when
to charge your EcoSharp
®
iBAT40 or EcoSharp
®
PRO
iBAT40XR lithium-ion battery pack.
• You can "top-off" your battery pack's charge before starting
a big job or after a long day of use.
Fig. 5
Washers
Chute deflector
Fig. 6
Deflector knob
Carriage bolt
Charge level button
The battery is at 30% capacity
and requires charging
The battery is at 60% capacity
and requires charging soon
The battery is at full capacity
Light Indicators
Lights
