14
Operating Tips
• Start the hybrid snow shovel and tilt it forward until the
scraper blade at the base of the unit contacts the ground.
Push the shovel forward at a comfortable rate, yet slow
enough to clear the path completely. The clearing width of
the hybrid snow shovel and the depth of snowfall should
dictate your forward speed.
•
Direct the snow discharge to the right or to the left by
holding the hybrid snow shovel at a slight angle.
• To remove snow most efficiently, throw the snow
downwind and slightly overlap each swath.
• If you need to clear snow from a crushed rock or gravel
surface, push down on the handle to keep the scraper
blade clear of any loose material that the rotor blades
could throw.
• This hybrid snow shovel cuts a path 13 in. (33 cm) wide
and up to 6 in. (15 cm) deep in one pass.
• When clearing deeper drifts, hold the hybrid snow shovel
by the upper and lower handles and use a swinging or
sweeping motion. Remove up to 6 in. (15 cm) of snow with
each pass and repeat as many times as needed.
•
Remove the battery after using the hybrid snow shovel.
Hang the shovel so it will not be misplaced or damaged.
Maintenance
To order genuine replacement parts or accessories for the
Snow Joe
®
iON13SS-HYB hybrid snow shovel, please visit
snowjoe.com or contact the Snow Joe
®
+ Sun Joe
®
customer
service center at 1-866-SNOWJOE (1-866-766-9563).
Proper Care for B Charger
m
WARNING!
To reduce the risk of injury, always unplug
the charger and remove the battery pack from the charger
before performing any maintenance task. Never disassemble
the battery pack or charger. Contact your Snow Joe
®
+
Sun Joe
®
dealer or the Snow Joe
®
+ Sun Joe
®
customer
service center for ALL repairs.
1.
To reduce the risk of injury and damage, never immerse
your battery pack or charger in liquid or allow any liquid to
flow inside these components.
2. Clean out dust and debris from charger vents and
electrical contacts by blowing with compressed air.
3. Use only mild soap on a damp cloth to clean the battery
pack and charger, keeping away from all electrical
contacts. Certain cleaning agents and solvents are harmful
to plastics and other insulated parts. Some of these
include gasoline, turpentine, lacquer thinner, paint thinner,
chlorinated cleaning solvents, ammonia, and household
detergents containing ammonia. Never use flammable or
combustible solvents around battery packs,
battery chargers or tools.
4.
The iONMAX iBAT40 lithium-ion battery charger has no
serviceable parts.
Replacing the Auger
m
WARNING!
Make sure to turn off the switch, disconnect
the power cord, and remove the battery before performing any
maintenance task on your hybrid snow shovel.
1.
Disassemble the left side cover by removing the five
screws that hold it in place (Fig. 17).
2. Remove the belt from the drive wheel (Fig. 1
8
).
3. Remove the screws and the bushings from the drive wheel
(Fig. 19).
Fig. 17
Fig. 18
Belt
Drive wheel
Fig. 19
Screws and
bushings
Drive wheel
Summary of Contents for iON13SS-HYB
Page 20: ...snowjoe com...
