SNOWJOE ASHJ202E, Operator'S Manual

Page: 9 / 16

9
2. Remove the wire filter basket by turning it
counterclockwise. Tap out the basket to remove any
accumulated residue (Figs. 11 – 12).
3. Take out the pleated filter and tap it clean. Remove any
debris with a clean and dry paintbrush or hand brush
(Fig. 13).
NOTE: Do not wash the pleated filter in water.
4. After cleaning, r eplace the pleated filter on the motor and
filter housing located on the underside of the container lid
(Fig. 14).
NOTE: Check that the rubber rim of the pleated filter is
seated flush against the container lid.
5. Fit the wire filter basket over the pleated filter and turn it
clockwise until it stops. The wire filter basket tabs must
cover and depress the safety stop switch.
NOTE: Make sure the wire filter basket tabs are under the
metal retainer clips.
Cleaning the Air Filter
1. Take off the container cover, wire filter basket and
pleated filter.
2. Take the air filter out of the filter housing (Fig. 15).
3. Clean the filter with soap and water and let it air dry.
4. Place the air filter back into the filter housing and
reassemble the pleated filter and the wire filter basket.
Cleaning the Pre-filter
1. Gently clean the pre-filter with water and hang to dry.
NOTE: Make sure not to rub the cloth when cleaning as this
could damage the coarse cloth grain.
Fig. 11
Wire filter
basket
Fig. 12
Wire filter
basket
Fig. 13
Pleated filter
Fig. 14
0 mm
Fig. 15
Air filter