Lit. No. 43755/43757/43873, Rev. 01
18
March 15, 2016
WIRELESS CONTROL PROGRAMMING AND PAIRING
WHEN TO PROGRAM AND PAIR THE
WIRELESS KEY FOB CONTROL
The wireless key fob control included with the
spreader should come paired and ready for use.
If the spreader does not respond to the
wireless key fob control, or after replacing the
battery (CR2032 battery or equivalent), you will need
to program the wireless key fob control and pair it to
the spreader's wireless control module.
ENSURING THE SPREADER HAS POWER
The spreader is only compatible with
7‑way RV style trailer plugs. If your vehicle
is not equipped with a 7‑way trailer plug,
contact Customer Support to purchase the
necessary electrical harness (PN 75924).
1. The spreader must be receiving power
from the vehicle to pair and program the
wireless key fob control. Begin by
unplugging the
spreader from the 7‑way plug.
2. Push the toggle switch DOWN into the
"MANUAL OVERRIDE" position.
3.
Plug the spreader into the 7-way plug. Be sure to
check that the plug polarity is correct as shown
below. The spreader will start at 100% speed.
4. Unplug the spreader, push the toggle switch into
the center position and then reconnect power to
the spreader.
The spreader must be unplugged after running
an override. The wireless key fob control will
remain locked out until power is removed from the
spreader unit.
5. If power is not present, consult the trailering
section in the vehicle owner's manual for more
information.
Spreader Power Plug End View
Battery Power POSITIVE (+)
Black Wire
Battery Ground NEGATIVE (–)
White Wire
WARNING
The spinner will start immediately upon
connecting power while in manual override
mode. Keep hands and tools clear of spinner
assembly.
