© Trynex International 2012 (REV A) F50723
6
Operating the Spreader
Model # SP-575V
SPREADER LOADING
WARNING
– Do not overload vehicle. Use chart below to calculate weight of material. Weights of material are an average for
dry
materials.
Material
Weight Per Cubic Ft.
Rock Salt
80-90 lbs.
Sand/Salt Mix
95-120 lbs.
•
Warning – Never leave material in hopper for long periods of time as salt is hygroscopic and will attract atmospheric moisture and harden up.
When spreading sand mix, a 1:1 ratio for Sand/Salt mix is recommended to prevent the material from freezing.
SPREADER OPERATION
• The variable speed controller has finger-tip dial action, digital system status with warning protection and blast feature.
•
To start, press On/Off button on Control Pendant. Press Start/Stop button and Spinner will accelerate to speed set on dial.
•
To stop, press Start/Stop button. Press On/Off button to turn off Spreader
•
Adjust speed of Spinner using dial in center of Control Pendant
•
If more material is needed in certain areas, press the Blast button to give maximum power.
SPREADING TIPS
•
Spread ice melters with the storm to prevent unmanageable levels of ice.
•
Never exceed 10 miles per hour when spreading.
•
For a wider pass, increase spinner speed.
•
For a heavier pass, drive slower.
•
Never operate spreader near pedestrians.
•
Calculate spread pattern when near vegetation.
LICENSE PLATE INSTALLATION (IF REQUIRED BY LOCAL LAWS)
• You will need (2) 1/4-20 X 1/2” machine screws along with nylock type nuts (not included with spreader)
• Install license plate to mounting holes provided in hopper apron (see illustration below)
Mounting Holes
