2
16992440 Rev A
TABLE OF CONTENTS
1.
Warnings/Vehicle Application ........................pg. 2
2.
About the plow ..............................................pg. 3
3.
Registration Information/Website ..................pg. 3
4.
Snowplow Mounting/Dismounting ................pg. 4
5.
Mechanical Installation ..................................pg. 6
6.
Harness Installation ................................... pg. 6-7
7.
Storage and Maintenance .............................pg. 8
8.
Parts Diagram and BOM ..........................pg. 9-12
•
Lift Frame ..................................................pg. 9
•
Moldboard ...............................................pg. 10
•
Hydraulic Power Unit............................... pg. 11
•
Hydraulic/Electrical Operation ................pg. 13
9.
Troubleshooting ...................................... pg. 14-15
10.
Snow Plowing Tips ......................................pg. 16
11.
Warranty ......................................................pg. 16
WARNING
Always follow the vehicle manufacturers
recommendations relating to snowplow
installation. For recommended vehicle models
refer to the SnowDogg Application Chart and
Selection Guide.
WARNING
Make sure plow is properly attached before
moving vehicle.
WARNING
Do not move plow while servicing or place body
parts between or under plow parts while moving
plow.
WARNING
DO NOT change blade position when traveling.
WARNING
DO NOT exceed 40 mph when transporting plow.
WARNING
Do not exceed 10 mph when plowing.
WARNING
Always lower blade when vehicle is not in use.
WARNING
Read this manual carefully before operating this
snowplow.
CAUTION
Vehicle application recommendations are based
on the following:
• The vehicle with the snowplow installed must
comply with the vehicle manufacturer's stated
gross vehicle and axle weight ratings (found on
the driver-side door corner post of the vehicle)
and the front and rear weight distribution ratio.
In some cases, rear ballast may be required to
comply with these requirements.
• In some cases there may be additional limita-
tions and requirements.
• Available capacity decreases as the vehicle is
loaded with cargo or other truck equipment, or
snowplow accessories are installed.
• If there is uncertainty as to whether available
capacity exists, the actual vehicle as configured
must be weighed.
