6
15.1
Automatic engine oil level protection
This safety system shuts down the engine before the oil level
falls below a safe level. The system will also detect a critical tilt
of the engine and also shut it down. This will prevent possible
damage to the interacting parts working with insuffi cient
lubrication. Engine switch will remain in “ON” position. If the
engine has stalled and does not start, check the engine oil level
before performing diagnostic study.
15.2 Safety device (if applicable)
The safety device protects the charging circuit of the battery in
case of short circuit or improper connection. When triggered, the
device shows green button switch. Before returning it back into
place, you should locate and eliminate the cause.
To restore the circuit, press the breaker button.
16
Stopping the engine
In case of emergency:
To shut down the engine in case of emergency, turn the engine
stop button switch to “OFF” position. Or pull out the
emergency engine kill switch.
In normal cases:
1. Adjust the throttle lever to lower RPMs .
2. Turn the engine stop butto to switch to “OFF” position.
3. Close the fuel valve (if avalialable)
17 Maintenance tips
17.1
Changing the oil
Change the oil in the engine produce in accordance
recommendations to the operator`s manual engine.
!
Caution
!
Do not touch the muffl er immediately
after the engine is stopped in order to
avoid getting burned.
17.2 Replacement CVT belt
1. Turn off the engine,
2. lock the parking brake.
To replace the CVT belt, pull the belt off the large pulley and
then from the CVT (as per picture below). Install the belt in the
reverse order.
Replace the CVT belt, if it`s worn out or its width is less than
0,78 in.
17.3
Servicing the CVT (ZM184)
As the CVT belt wears, it reduces performance of the Snowdog
and can cause overheating and jamming.
When replacing a worn belt or when you notice a reduction in
performance caused by a worn belt, clean and grease the CVT
as described below.
1. Remove the CVT pulley from the crankshaft of the
engine
2. Remove the washer, unscrew the nut, disassemble
CVT
3. Rinse the CVT mounting seats rollers and rolling
places with gasoline.
