8
7.1.1 Battery installation
1. It is necessary to install and connect the battery
before using the Snowdog. You will need a battery
(supplied with the Snowdog), a metric wrench (is not
provided as standard) and a Philips screwdriver (not
included).
2. Unscrew 2 bracket mounting screws using metric
wrench.
3. Install the battery and tighten it with the bracket
using the metric wrench.
4. Connect the electric wires to the battery, strictly
observing the polarity. Wire with the red cover is
connected to the cleat marked with “
+
” sign, wire
with black cover is connected to the cleat marked
with “
-
” sign. Tightly secure the contacts.
General view of the assembled battery is shown below.
!
Warning
Pay attention to the polarity when connecting the
battery!
Do not switch on the headlight if the battery is not
connected!
The voltage of the charged battery should be
within the range of 12.6–12.9 V. If the battery
voltage is less than 12.6 V, it must be charged.
Use chargers designed for AGM batteries. Do not
use chargers with voltages above 14.6 V as they
will damage the battery.
7.1.2 Cargo box installation (if available)
Put the cargo box into luggage compartment. Align the
holes in the box and on the frame.
Install the plates
(1)
and tighten the screws
(2)
.
2
1
7.1.3 Handlebar height adjustment
To adjust the height of the handlebar you must rearrange
fixture in one of the three holes
(1)
. In order to raise the wheel
higher, move the mounting holes in the bottom. In order to
lower the wheel, move the handlebar to the upper hole.
Please NOTE, both mountings of the handlebar must be on
the same level.
!
Warning
Special attention shall be paid to the fastening of
the handlebar, as well as to the attachment of the
wiring and cables for throttle and parking brakes.
Make sure that they are not caught between the
handlebar and the crossarm. Make sure the wiring
and cables are not stretched when the handlebar
is unfolded. Make sure the wiring and cables
are not breaking or damaging when folding the
handlebar.
Do not press the handlebar during operation on
hard surface. Do not lift the front of the Snowdog
using the handlebar.
7.1.4 Installation of handguards
!
Warning
Left and right handguards are different.
1. Attach the handguards to the handles with a screw
(1)
, bushing
(3)
and nut
(2)
but do not tighten.
2. Install a bushing
(3)
and a screw
(4)
through the
handguards.
3. Tighten the screws.
1
1
2
3
4