2. Installation
Handel Installation
Your wine cooler comes with a towel bar style handle. To install the handle,
you will need a Phillips head screwdriver.
1. Open the door.
2. Pull out the door seal from the top right corner of the door frame.
3. Insert the screws from the inside of the door frame (ensure that you are
able to see the tips of the screws protruding from the other side of the door
frame.)
4. Align the screw holes of the handle bar with the tips of the screws.
5. Tighten both screws from the inside.
6. Press the door seal firmly back into place.
2
3
5
4
1
Note: On some wine cooler models, the handle can be installed in either side
of the door frame. To install the handle in the right side of the door frame, use
a small flat head screwdriver to pry the caps out of their holes and follow the
above instructions.
1. Remove all packaging.
2. Set up the wine cooler on a level surface. Make sure you have at least
2” clearance on each side and 4” clearance in the back for ventilation.
3. Clean the interior surface with warm water and a soft cloth.
4. Insert power cord into a power socket. Maker sure the power socket is
grounded 115v ~AC / 60 Hz socket.
5. Fill the wine cooler with your choice of wine bottles. Allow up to 24
hours of operation for the bottles to reach the desired temperature.