Sno-Way 99101398, Installation & Owner'S Manual, Page: 8 / 16

8
Pairing Receiver and Transmitter
Every transmitter has its own unique code. In order to
operate the plow or spreader, the receiver must "learn"
the transmitters code. The receiver will only function with
a transmitter it has been paired with. That way several
wireless units with different transmitter codes can function
in the same area. Each receiver can "learn" one
transmitter code.
1. Ensure vehicle bumper connection is made and
vehicle supply voltage is 12VDC. Also verify that the 14
and 4 pin (when present) connectors are connected from
the receiver module to the power unit. A red blinking LED
indicates the receiver has power and is not
communicating with a transmitter.
2. Turn the ProControl 2 Plus™ transmitter on, and put
it into Pairing Mode by pressing and holding the Down
pressure button or pairing button for at least 5 seconds,
but not more than 10 seconds. When the button is
released, the backlights will flash continuously and the
transmitter will be in pairing mode.
NOTE: Refer to "OPERATION" section for button details.
3. Place a magnet into the divot on the backside of the
receiver module. (See Figure 1-1). Remove the magnet
and the LED on the receiver will alternately flash green
and red to indicate the receiver is in pairing mode.
4. When the receiver and transmitter are paired, the DP
light (plow) or salt light (spreader) will flash three times
and the LED on the receiver will flash green three times
and then flash red. When this happens, push the DP
(down pressure) button or pairing button to exit pairing
mode.
NOTE: If the DP light or salt light on the transmitter does
not flash and the LED on the receiver does not flash
green three times before going back to flashing red, the
pairing attempt has failed. Go back to step 1 and repeat
steps.
5. After exiting pairing mode, the back lights and DP
light or salt light on the transmitter will flash alternately 4
times. Then the DP light or salt light on the transmitter will
flash three times and the signal light on the transmitter
and LED light on the receiver will change to flashing
green. Once this occurs the control is ready to use.
NOTE: Each transmitter can be paired to one plow
receiver and one salt spreader receiver at the same time.
The pairing process is the same for either receiver.