6
7. Coat main wing pivot pin with grease and insert
through the tower and wings. Leave top of pin
approximately 1" above the tower. (See Figure 1-6.)
Figure 1-6
8. Take deflector and place on tower with the tab on the
wing pivot pin going thru the rectangular hole of the
deflector. Align bolt holes in the wing pivot pin, deflector,
and tower. Push wing pivot pin down to the deflector and
tower. (See Figure 1-7.)
Figure 1-7
9. Secure the wing pivot pin to the tower assembly with
one 3/8" -18 x 1-1/4" cap screw and 3/8"-18
Locknut.(See Figure 1-7.)
10. Attach angle cylinder base to tower with a
5/8" x 2-7/8" clevis pin. Insert cotter pins into clevis pins. .
Attach angle cylinder rod to blade with a 1/2"-13 x 2-1/2"
cap screw and 1/2"-13 locknut. (See Figure 1-8.) Repeat
for opposite angle cylinder.
Figure 1-8
11. Attach a plow marker to each wing as shown and
secure using 5/16" x 1" cap screws and locknuts. (See
Figure 1-9.)
Figure 1-9
DS WING
WING
PIVOT PIN
PS WING
DEFLECTOR
3/8"-18
3/8-18 x 1-1/4"
CAP SCREW
LOCKNUT
1/2"-13
LOCKNUT
CAP SCREW
1/2"-13 X 2-1/2"
CLEVIS PIN
5/8" x 2-7/8"
COTTER PIN
ANGLE
CYLINDER
5/16" x 1"
CAP SCREWS
PLOW
MARKER
Summary of Contents for 26V Series
Page 34: ...33 MAIN WIRING HARNESS SCHEMATIC EIS Energy Interruption SystemTM ...
Page 36: ...35 NOTES ...
Page 37: ...36 NOTES ...
