3
Receiver Installation on Plow Power Pack
1. Loosen the four screws holding the pump cover in
place and then lift and remove the pump cover.
2. Remove the 1/4" x 6" capscrew and 1/4" nylock nut
from the top of the two channels located in front of the
power unit reservoir.
3. Insert the antenna wire through the loop on the
receiver. Slide the receiver box into the two mounting
channels with the exposed wires of the receiver box
positioned toward the truck, and the antenna wire on top.
Figure 1-1
4. Re-install the 1/4" x 6" capscrew and 1/4" nylock nut
previously removed and tighten to 7 to 9 Ft. Lb. torque.
5. Connect the 12 terminal connector on the receiver
unit to the 12 terminal connector on the snow plow power
pack.
.
6. Connect the single black ground wire on the receiver
to the 5/16" bolt where the plow ground wire is attached
to the power unit.
FCC Statement of Conditions
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules and
with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
RF Exposure (OET Bulletin 65)
To comply with FCC RF exposure requirements for
mobile transmitting devices, this transmitter should only
be used or installed at locations where there is at least
20cm separation distance between the antenna and all
persons.
Industry Canada Statement
The term "IC" before the certification/registration number
only signifies that the Industry Canada technical
specifications were met.
Programming Receiver to Learn
Transmitter Code (Wireless Control)
Hard-wired control systems do not require the receiver to
"learn" the transmitter code. Owners with hard-wired
controls can proceed to the next section.
Every transmitter has its own unique code. In order to
operate the plow, the receiver must "learn" the
transmitters code. The receiver will only function with a
transmitter it has been programmed for. That way several
wireless units with different transmitter codes can function
in the same area. Each receiver can "learn" one
transmitter code.
CAUTION
The connectors must be plugged in correctly.
The connectors are keyed; you must line up the
slots with the tabs when plugging in the
connectors. Failure to do so WILL CAUSE
FAILURE of the receiver. When plugged in
correctly, the wire colors on each connector will
match.
ANTENNA WIRE
RECEIVER BOX
MOUNTING CHANNEL
TRUCK
INSTALLATION
