EN – 27
7.
Secure attachment sheave to crankshaft with one
locking washer and hex bolt.
8.
Reinstall idler spring to traction drive idler.
9.
Reinstall attachment drive belt onto attachment
sheave.
To assist belt installation, slowly pull recoil starter handle
while gently guiding belt into attachment sheave.
10. Reinstall belt finger and secure with two flat steel
washers, two locking washers and two hex bolts as
shown in Figure 6.
11. Check belt finger clearance:
• Engage attachment clutch lever and make sure belt
finger located opposite belt idler is less than 3.2 mm
(1/8") from belt, but not touching the belt.
• If needed, adjust clearance by loosening hex bolts,
repositioning belt finger, and tightening bolts.
12. Reinstall belt cover and tighten hardware.
13. Reconnect spark plug wire and fill fuel tank.
WARNING:
AVOID INJURY. Attachment sheave
edges are sharp. Wear thick gloves to install belt
onto attachment sheave.
Figure 55
Figure 56
Figure 57
