Vega-MV Router Multiviewer - User Manual
Issue 1 Revision 2
Page 181
© 2017 SAM
Configuring Each Multiviewer Input with a Router Controller
Connection to Other Equipment 9.9
9.9 Configuring Each Multiviewer Input with a Router Controller
After each router controller has been set up on the Vega-MV, then each Vega-MV multiviewer
input can be configured to get information from a router. This is done on the SAM Router
Network tab (Module > Setup Module > Protocols > SAM Router Network), in the ‘Video
Router’ tab. See Figure 140.
These tabs comprise a table of multiviewer inputs (rows) and router controller connection
parameters (columns). See Table 70.
Figure 140 SAM Router Tabs: ‘Video Router’, ‘Ext Audio Router’, and ‘Data-xx Router’ Tabs
Column Item
Description
MV Input
Column is not editable.
Input number of the Vega-MV unit.
Numbered from 1 to 16 (Vega-16MV) and 1 to 32
(Vega-32MV).
Controller
Drop-down box.
Select the router controller which is controlling the source of
this MV Input.
Table 70
Columns of ‘Video Router’ Tab