Vega 30 Router User Manual
Making User-defined Sources
Sources and Destinations 9.4
Issue1 Revision 1
Page 170
© 2017 SAM
9.4 Making User-defined Sources
User-defined sources are made via the Vega 30 Web interface or RollCall interface using the
following pages:
•
Vega 30
Source Names
Web page.
See Section 7.4 “Source Configuration Template” on page 113.
•
Vega 30 Rollcall
Source Configuration
template.
See Section 6.3.3 “Source Names Web Page - Source Names Table” on page 57.
Only channel source names or numbers of the physical Vega 30 unit or of internal Vega 30
sources may be entered on the screens. Do not enter any User-defined source names nor
numbers.
For the RollCall template, video sources and audio channel sources are displayed as either
names or as numbers. Either a name or a number may be entered. If sources names are
being shown, then an entered a source number will show as the corresponding name after
pressing carriage return (<cr>). And vice versa.
Entering a zero (0) in the RollCall template clears the entry in the Source Configuration
screen and enters ‘no channel source’.
Names are case insensitive.
Note:
In the RollCall
Source Configuration
template,
enter either a number, or a name, or a zero.
In the
Source Names
web page,
enter either a number, or a name, or a blank (i.e. clear the table entry and press
enter
).
Press the
enter
or
return
key to finish.
