Power & Status Check
Page
9
©
2016
SAM
Power & Status Check
Power
A Vega 100 Series router is supplied with either one or two Power Supply Units (PSUs).
Connect the supplied IEC mains cord to the PSU 1 rear inlet.
If a second PSU is fitted,
connect a second IEC mains cord to the PSU 2 rear inlet.
Connect the IEC cord(s) to a live mains source; the Vega will power up.
Front LED Status
Check the status of the front LED indicators after power up.
See Figures 8 (Vega 200 and 400) and Figure 9 (Vega 700).
Check the LEDs are correct for the PSU, Controller (CTL) and Crosspoint (XP) redundancy
router options fitted.
Troubleshooting
If the LED colors displayed are not as shown in the figures, please ensure that:
1.
The mains supply is on and the power cord(s) are connected securely.
2.
The PSU(s) and cards are all firmly seated.
If further support is required contact your local SAM representative. Contact details can be
found by visiting
www.s-a-m.com/support/247-support-contact-details
and clicking on
the Support tab.
and clicking on the Support tab.
Note:
For Vega 200 & 400 - see Figure 7 and Figure 8.
For Vega 700
- see Figure 9 and Figure 10.
