MV-805 IP Multiviewer User Manual
Source Spigot Template
RollCall Templates 6.8
Issue1 Revision 1
Page 75
© 2018 SAM
6.8.1 Changing Source Flow
For each multiviewer source spigot, two flows are supported:
•
Video
and
Audio
.
For each flow, the template has the following sections:
•
Current:
Shows information about the current IP stream originating from the spigot.
•
New:
Allows a user to enter new IP stream details.
Each section has a
Primary
and
Secondary
sub-section, which are for redundant flows.
Once new IP stream information is entered, a
Take
button appears at the bottom of the
window. Click
Take
to apply the new IP stream settings.
To change the source multiviewer output IP stream information:
1.
Select a spigot. (See Table 23.)
2.
Enter all the new details for each flow. (See Table 25.)
(For Video and Audio flows in Fabrics “A” and “B”.)
A TAKE button appears at the bottom of the screen.
3.
Click TAKE to apply the new multicast IP stream details.
New MultiCast Flow
Setting
Description
Flow Information:
For each of the flows, the following information is presented:
Multicast IP
Text box.
Enter the IP Address of the multicast stream.
Dst Port
Text box.
IP Port number to be used by the flow’s destination (i.e. the multicast stream).
Src Port
Text box.
IP Port number to be used by the flow’s source device (i.e. the Multiviewer).
Table 25 Multicast Flow Information for Selected Source Spigot
Item
Description
Take
Button.
Click
Take
to make a routing to a source spigot (MV-805 output) or
apply a settings change.
Table 26
Take (Source Spigot Screen Item)