LC2000/LC2000-IQ/LC4000/LC4000-IQ
System Setup Menus
Issue 1 Rev 6
Page 37
© 2015 SAM
7.2.3 CVBS Encoder C and D – CT2 Configuration
Each slot has two composite video connections.
•
Source:
Use to route the appropriate processing channel to the chosen CVBS
encoder.
•
Format:
Specifies the CVBS output standard. The options are:
•
PAL/NTSC
•
PAL-M/PAL-N
•
PAL/NTSC-J
7.2.4 CVBS Encoder A, B, C, D – CE4 Configuration
Each slot is available as a composite encoder.
All controls are the same as the Section 7.2.3 CVBS Encoder C and D – CT2 Configuration
controls.
7.2.5 Routing a Processing Channel
To route a specific processing channel output to a CVBS output:
1.
From the System menu, select CVBS > CVBS Encoder C (or D) > Source.
2.
Choose the processing channel you want to route to this slot, then select Done.
3.
From the CVBS menu, select Format.
4.
Choose the format of the composite output, then select Done.
For example, to create a PAL composite output on slot C1 where the converted output has
been downconverted using processing channel 2:
1.
Select CVBS > CVBS Encoder C > Source, Ch 2, then select Done.
2.
Select CVBS > CVBS Encoder C > Format, PAL/NTSC, then select Done.
Note:
If an illegal signal such as HD video is routed to a CVBS encoder, there will be no output
signal from this connector.
