IQUDC30/IQUDC31/IQUDC32/IQUDC33
Operation Using the RollCall Control Panel
Issue 1 Rev 4
Page 90
© 2016 SAM
5.16.5 Command
Command enables a command to be sent to the selected destination unit. Each RollTrack
command comprises two sets of numbers, for example, 33039:3.
•
The first set, 33039 in the example, is the RollTrack command number, which
identifies the command.
•
The second set, 3 in the example, is the value sent with the command.
5.16.6 RollTrack Sending
Rolltrack Sending shows information when the unit is sending a RollTrack command.
5.16.7 RollTrack Status
RollTrack Status shows information about the status of the selected RollTrack Index.
5.16.8 Configuring a RollTrack Action
1.
Use the Index slider to select the Index number. This identifies the RollTrack action
being configured. You can create up to five RollTrack actions.
2.
From the Source list, select the source that will trigger RollTrack transmission.
3.
In the Address field, enter the RollTrack address and click S to set. To return to the
preset value, click P.
4.
In the Command field, enter the RollTrack command and click S to set. To return to
the preset value, click P.
5.16.9 Viewing RollTrack Information
See see section 5.16.6 and see section 5.16.7.
No
The command is being sent.
Yes
The command is being sent.
OK
RollTrack message sent and received OK.
Unknown
RollTrack message has been sent but has not yet completed
Timeout
RollTrack message sent, but acknowledgement not received. This
could be because the destination unit is not at the specified location.
Bad
RollTrack message has not been acknowledged at the destination
unit. This could be because the destination unit is not of the type
specified.
Disabled
RollTrack sending is disabled.
