IQUDC30/IQUDC31/IQUDC32/IQUDC33
Connections
Issue 1 Rev 4
Page 30
© 2016 SAM
3.10.5 SFP
3.11 IQUDC3203-2A(B)3
3.11.1 SDI Inputs
3.11.2 SDI Outputs
3.11.3 GPIO
3.11.4 Reference Input
Operation to full specification is only possible with a correctly terminated, noise-free, stable,
black sync reference input. While lock may be achieved with an unsuitable sync source, the
increased jitter evident on the SDI output will affect locking and cable length performance at
the receiving equipment.
A dual SFP connector offers support for a
variety of SFP options (see page 12).
Two ports provide dual TX, dual RX, or a
TX/RX combination, dependent on the
module fitted.
Serial digital inputs to the module are made
via two BNC connectors which terminate in
75 Ohms.
Serial digital outputs from the module are
made via four BNC connectors which
terminate in 75 Ohms.
General Purpose Interface (GPI) connections
are made via a 3-pin closing-contact screw
terminal connector.
Connections can be inputs or outputs.
An external sync input to the module is made
via passive loop-through BNC connectors
which terminate in 75 Ohms.
Note:
If the loop-through facility is not used, the unused BNC socket must be fitted with a 75 Ohm
terminator.
